An innovative mechanical steel earthquake-resistant solution helps new and existing buildings to better withstand the impact of earthquakes without a power source. 


Seismic damper systems are designed to improve a building’s structural integrity and to reduce the impact of ground movement on it in the event of an earthquake. Typically, seismic dampers are integrated into a building at the point of construction and often require a power source.  Professor Moussa Leblouba, who works at the Department of Civil and Environmental Engineering at the University of Sharjah in the United Arab Emirates, was intent on fixing some of the problems inherent to existing damper systems.

“The device was first conceived in early 2016,” he explains. “I developed it to solve a few problems with existing dampers, such as fluid leakage, the need for complete replacement after experiencing one earthquake, and the active damper’s dependence on electrical power.

“What I have created is a passive damper. It consists of a steel cylinder filled with small steel balls. A shaft with short rods protruding radially from it passes through the cylinder and its two ends extend outside of it and connect to the structure.

“When an earthquake shakes the building, the shaft moves back and forth along the cylinder. The rods are dragged through the balls, and the friction between them converts the seismic energy into heat. The structure, therefore, has to absorb less of the energy, and the damage to beams, columns and connections is reduced.”

This device can be installed after a building is constructed, making it suitable for retrofitting, as well as for new construction.

An earthquake-resistant system that doesn’t require a power source

Leblouba’s solution does not need an electrical power source, which is crucial as power is often lost during an earthquake. “It also works at small displacements, such as those due to wind or train vibrations, and at large displacements, such as those due to strong earthquakes,” says Leblouba.

“It does not remain in a deformed state after the shaking stops, and if it is damaged, it can easily be rebuilt or replaced as it is made of a small number of simple parts that can be obtained from standard workshops.”

In laboratory cyclic tests, the average effective damping ratio of the device was about 14%. It has not yet been tested on an actual building.

Steel was the go-to material for this earthquake-resistant system

Its strength and durability made steel the natural material for Leblouba’s solution. He says: “The device works through repeated friction between hard surfaces, and steel is hard and durable enough to withstand thousands of cycles of such contact. Steel is also cheap and widely available, which keeps the device affordable and easy to make or replace.

“In addition, engineers already know how to specify, fabricate, and connect steel to existing buildings. In our prototype, the cylinder, shaft, rods, and balls are all made of steel. It should be noted, however, that the steel balls can be replaced by other granular materials, such as sand or gravel.”

The device is patented through the University of Sharjah (US Patent 12,498,014).